Knife Build #17


I ordered this Hock Paring Knife Kit from Hock Tools.

The 3.5 inch paring knife kit consists of a wonderful Hock blade and the necessary pins. The kit is Model #KP350.

This knife is for my niece, Wynn.

It will have handle scales from redheart.

For the most part, all of the steps in this process are identical to the first knife.

The entire knife 1 build process can be seen here.


Info about knife kits is available at Hock site




Wood Selection and Scale Prep

The #KP350 blade is made from high-carbon tool steel.

It was forged in France and sharpened by Ron in California.

PDF Hock Knife Kit Instructions



The redheart blanks for the scales.

This knife is part of a group of six that are all concurrent builds.

The scales will be from cocobolo, purpleheart and redheart.

The blade was covered in tape for protection. The blade comes incredibly sharp.
Blades wrapped for safety and the scales are assisgned.
After drilling holes in the scales for the pins and rounding the front ends...the blank is ready to be ripped at the bandsaw.
...ripped roughly in half.
Dry fit of the scale blanks and the pins...ready for epoxy.

Epoxy Setup


The inside surfaces of the scales and the tang of the blade were sanded to 150x to provide a better adhesion surface.

Then the mating surfaces and the pins were cleaned with acetone.

I chose a strong, water-resitant epoxy adhesive, Devcon 2 Ton® Epoxy...comes in two 4.5 oz. bottles.
To mix...equal dollops of the resin and the hardener were squeezed out.
then mixed...

The adhesive was then spread on to one side of the tang...then the knife tang and scales are clamped.

Rapid dry in 15 minutes, reaches functional strength in 1 hour.

Tang, pins, and scales epoxied...Clamped up with Bessy hand clamps...


Epoxy set...out of the clamps...ready for grinding and sanding...




After glue up, the next phase was the grinding of the wood and the metal which was done on a belt sander with 80x paper.

I try to avoid dust so I ran both shop air filter systems and wore a protective mask.


Here is the knife after the grind down.

Secondary grinding of the pins was done on the 1 x 30 belt sander with 80x paper.

Further removal of metal and wood was done with the Rotex 90 sander with 40x paper.

After all the metal and wood was taken down to proper size, the grits were progressed on the Rotex 90 from 40x-80x-120x-220x-320x-400x.


The finishing cycle consisted of multiple coats of Waterlox wiping varnish.

Each coat was saturated and then dried using wet/dry sandpaper.

Two saturations and rub-ins were done at 400x-and 600x and then single saturations at 800x, 1000x and 1500x.


All of the sanding and finishing is completed in this image.

The finish was extremely smooth.





Return to Shop Index