MatchFit
Alterations and Jigs |
I purchased some MatchFit clamps, a dovetail bit, and accessories...these
enabled me to route grooves and make some appliances...manufacturer's
examples to the right...
|
|
On the crosscut sled...I routed
through grooves that are parallel to the fence...had to make sure they
were not in line with the screws to the mitre bars. |
|
Used the Festool guide to create some grooves parallel to
the front edge and to the back fence.
|
|
The routed dovetail groove is mated with a dovetail clamp.
|
|
Routed a groove in the top of the fence. MatchFit clamps
will run anywhere in this groove...
|
|
Example...holding a block stop... |
|
Jigs with grooves routed into
them can be clamped to the fence on the outside... |
|
Custom jigs, appliances, and stops
can be placed anywhere along the fence using knobs from MatchFit. |
 |
Dovetail shaped plates with bolts
run in the groove...handles tighen. |
|
Some other uses...a 10 inch
tall fence for the tablesaw... |
|
...laid flat it becomes a sled
for straightening an edge...or tapering an edge... |
|
A 3 inch fence... |
|
...under bench MatchFit clamp
storage... |
|
| |
|
